Search results for "Cooling rates"

The X-ray determination of the amounts of the phases in samples of isotactic poly(propylene) quenched from the melt at different cooling rates

1997

A new procedure for the determination of the amounts of phases in samples of isotactic poly(propylene) quenched at different cooling rates from the same melted polymer is described. According to the procedure, all the patterns corresponding to the same quenching series are simultaneously analyzed for the amounts of phases so that reliable phase fractions relative to the different samples of the series are achieved. The analysis of the results points out that for increasing cooling rates above 30°C/s a remarkable increase of the mesomorphic phase settles, mainly at the expense of the α-monoclinic one.

Crystallization kinetics in relation to polymer processing

1993

Phase distribution of quenched samples has been determined by a deconvolution procedure of WAXS spectra in a wide range of cooling rates. The informations collected together with isothermal and DSC results provide a very wide set of data on the crystallization kinetics of polymers relevant which covers conditions encountered in most polymer processing operations. They have been compared with predictions of a non-isothermal crystallization model assuming two independent and parallel crystallization processes competing during solidification.

Influence of plasticizers and cryogenic grinding on the high-cooling-rate solidification behavior of PBT/PET blends

2015

Two structurally different plasticizers (cyclic and linear) and the effect of cryogenic grinding on the solidification behavior at high cooling rates by a continuous cooling transformation approach of poly(butylene terephthalate)/poly(ethylene terephthalate), PBT/PET, blends are described. The solidification curve (density versus cooling rate) is confirmed as an effective tool to compare the differences in crystallization behavior under conditions mimicking processing. In comparison to the bulky cyclic plasticizer, the linear oligomeric one was found to have a more pronounced influence on the crystallization behavior. A 60/40 by weight PBT/PET blend shows a drop-off of density at ∼50 K/s. I…

Effect of cooling rate on the viscoelastic properties in the plastic zone of solid polymers

1979

PMMA and PC samples were subjected to several cooling rates from the glass transition temperature.

Thermoanalytical studies on phases of D-mannitol

1993

Abstract D-mannitol exists in several polymorphic crystalline forms. The conditions of crystallization are not well-defined, and in some cases mixtures of the different forms are obtained. In the DSC study the different forms melted nearly at the same temperature (166±°C). The heat of fusion of the k form was lower than those of the other forms. With slow heating rate (2 ° C min ) the δ form changed to k between 140 and 165 °C. The crystallization of D-mannitol from the melt gave from one to seven peaks in the DSC between 95 and 126 °C depending on cooling rates and the amounts of sample.

Characterization of cryoprotectants ternary mixture according to cooling rates

2015

Crystallization Behaviour at High Cooling Rates of Two Polypropylenes

1993

Phase distribution of quenched samples of two isotactic polypropylenes, having different molecular weight distributions, was evaluated by a deconvolution procedure of WAXD spectra. The dependence on cooling rate of the two resins shows the low molecular weights rich polymer is characterized by a faster kinetics with an α-monoclinic to mesomorphic transition taking place at higher cooling rates.